== Airborne Laser Scanner (ALS) processing == General Processing with a settings (.reg) file 1. Load in the reg file to set the specific settings for the project. * File > Load Settings 1. Set the Goto Folder to the main project directory * File > Set Goto Folder 1. Check the settings are appropriate for the project before proceeding (see below). This is important if using a reg file for a different project. 1. Add the raw SCN data * Click Add and browse to the parent raw data directory. This will add all flight lines in the immediate child directories. 1. Select POS filename * Click Browse and add the .sol file 1. Select the Output directory * Click Select > Goto Folder and select /ProcLaser. You should create directory if it doesn't exist. 1. Save settings for future re-processing purposes. * File > Save Settings 1. Run the processing * Run > Run == Setup of the system == * Hardware options. Once set these should never change (unless the system is modified etc) Should be supplied when the system is delivered. Can view/set these from File > Processing Options. * Output file options. Set the projection details, LAS file format, and whether want GeoTIFF or ASCII output awswell. Also contains options for debugging. * Input options * Atmospheric Correction. Need values of the altitude, temperature and pressure for a low altitude and high altitude. With these values a correction gradient will be produced. * Range Correction. A time-distance delay in metres of the ALS system, in the measurement of range data. (This is complicated...see user manual for details) * Scanner Correction. These do not need to be changed after the calibration/boresighting of the system. * POS errors. Angular difference between the IMU and the ALS optics reference frames. Needs to be known accurately. * Elevation offset. This is usually non zero. It is identified using the TScan Control Report (eh?). The LIDAR is then reprocessed using the opposite of the DZ offset. * Itenisty. Use the Raw intensity.