Version 7 (modified by mggr, 16 years ago) (diff) |
---|
Lever arm offset details
This page gives details of how the lever arm offset is calculated.
All nav is transformed back to the master antenna on the rear of the cabin roof, and then aznav transforms nav from there to each sensor as required when the individual sensor data is processed. AT4 nav is already wrt this antenna, and the IMU data is transformed back to the antenna during Applanix processing.
The distance is from the phase centre of the master (rear) antenna to each sensor's "prime" point; so for the ATM it is the scan mirror centre, for the Eagle, Hawk and CASI ideally the focus point of the lens.
The angles (as used in aznav) are: gamma is the positive angle from the vertical through the antenna to the sensor prime point and delta is positive to starboard from the centre line direction of the aircraft.
Initially it is necessary to make sure you have the correct sensor prime point coords as observed.
Then aznav sorts out what axis system has been used by the surveyors and swaps the cooridnates around until it gets it in the NASA Standard Aircraft system [ Y+ port, X+ tail to nose, Z+ up ]. Then do the angle calcs.
2009
Use 2008 for now but note that the instruments have moved! We need a re-survey or at least a measurement of the shift.
2008
18th Dec. 2008: Due to confusion about angle directions, the originally computed gamma angles are incorrect. The error caused should be of similar magnitude to the previous, similar error (ie ~1.5m along-track for ATM, other sensors will have a smaller error). Because the error will be partially compensated for by boresight angles depending on flight altitude, the "wrong" numbers should be used anyway unless you re-calculate the boresight angles.
Jan 2008 numbers (Wrong but use anyway, or we have to redo boresights):
Gam | Del | Dst | |
ATM | 1.2258 | 0.0051 | 1.7380 |
Eagle | 1.0748 | -0.0036 | 1.7441 |
Hawk | 0.9705 | -0.0049 | 1.7985 |
Jan 2008 numbers (Corrected for reference but use "wrong" numbers above, unless you've redone boresights):
Gam | Del | Dst | |
ATM | 0.3450 | 0.0051 | 1.7380 |
Eagle | 0.4960 | -0.0036 | 1.7441 |
Hawk | 0.6003 | -0.0049 | 1.7985 |
2007
Use 2006 numbers..
2006
Obs and results as follows:
v:200601 may 2006 2006 D-CALM instrument coords from SJR 9th May ------------------------------------------------------------------------------------------ z x y Z offset X offset Y offset dst gam del ATM 8.991 96.9065 99.9881 -1.68 0.4565 -0.0029 1.741 0.2655 0.006353 CASI 9.156 97.22509 99.98485 -1.515 0.775092 -0.00615 1.702 0.4732 0.007934 Eagle 9.143 97.7307 99.99 -1.528 1.2807 -0.001 1.994 0.6977 0.000781 Hawk 9.143 97.9155 99.99 -1.528 1.4655 -0.001 2.117 0.7644 0.000682 IMU 9.182 97.5181 99.8089 -1.489 1.0681 -0.1821 1.841 0.6287 0.1689 560 -1.476 1.4831 -0.0061 2.092 0.8264 0.004113 Pant 10.945 100.001 95.095 0.274 3.551 -4.815 Sant 10.906 100.000 104.91 0.235 3.550 5.000 Fant 10.843 101.661 99.989 0.172 5.211 0.079 ------------------------------------------------------------------------------------------ Aant 10.671 96.450 99.991 0.0 0.0 0.0 ------------------------------------------------------------------------------------------ Axes: Y+ port, X+ tail to nose, Z+ up Antennas: name, postion, AT4 name, survey name Aant = aft = master = GPS4 Fant = fore = slave_1 = GPS3 Pant = port = slave_2 = GPS1 Sant = starboard = slave_3 = GPS2 -------------- Sensor offset vector paras allowing for this coordinate system dx == X offset, dy = Y offset, dz = Z offset dst = sqrt( dx * dx + dy + dy + dz + dz ) gam = acos( abs(dz) / dst ) del = atan( dy / (-dx) ) Units: dst: metres, gam, del: radians ----------------- Verification test p = r = h = 0 ant1: lat: 52.0 lng: -3 hgt: 1000 IMU is at: lat: 52.00000959 lng: -2.99999734 hgt: 998.511013 ==========================================================================================