Changes between Version 19 and Version 20 of Processing/LidarCalibrationProcedure

Timestamp:

Oct 16, 2009, 4:20:20 PM (15 years ago)

Author:

knpa

Comment:

--

Processing/LidarCalibrationProcedure

@@ -115 +115 @@
  * Save the text file. 
 
-3. Preferably using data including areas of forest (little riss should do) and the BIT mode data, run Rangecardcal (from ALSPP tools menu) on all flightlines.
+3. Preferably using data including areas of forest (little riss should do) and the BIT mode data, run Rangecardcal (from ALSPP tools menu) on all flightlines. (on ~45 degrees?).
  * Enter the average dz value as A1 to get the other offsets. 
  * Add the outputs to the ALSPP dialog and save the settings reg file (to a new name)
 
 4. Analyse the results
- * Check these results and re-run using the full FOV (~45 degrees) on the low flightlines again.
+ * Check these results and re-run using the full FOV (~45 degrees) on the low flightlines again (remember to change output back to normal folder)
  * Check average dz is less than 1cm or so, and standard deviation <5cm in Terrascan control report. (also look at cross sections)
  * Then process the 4 high altitude flights in ALSPP and check in Terrascan (around nadir and swath edges) (looking at absolute height).