Changes between Version 15 and Version 16 of Sensors/LeicaLIDAR/MashUp

Timestamp:

Jun 11, 2009, 11:04:27 AM (15 years ago)

Author:

mark1

Comment:

--

Sensors/LeicaLIDAR/MashUp

@@ -291 +291 @@
  * The value is measured in "ticks" and will appear quite high as the shaft encoder has a high resolution (order of millions of ticks).
  * Measured in factory and provided by Leica.
+ * Can be easily checked on the ground by following this procedure:
+   * Start up the system on the ground (no GPS or installation required)
+   * run BIT mode
+   * turn off 'Position In' switch on the front panel - this will allow to snap the mirror on the centre
+   * Read F4's tick column, it should show real scan offset and it should be within +/- 500 ticks from the -10800 value
+   * turn on 'Position In' switch when finished
 
 
@@ -308 +314 @@
  * An accurate ground survey (see below).
  * Slow overflight for maximum point density.
+
 
 
@@ -471 +478 @@
  * Try to select areas where you can use the nearby geometry to help you
    * e.g. follow straight road edges to where they intersect another feature, so you have more than just one pixel to guide you to the intersection point in other images
+
    * avoid using building edges (perspective shifts)
  * Location of tie points
@@ -602 +610 @@
  * We can use TerraScan for creating projects, showing trajectories, splitting and combining LAS files.
  * Create new project – “first button” -> “offset stacked rectangle button”
+
  * file -> new  
    * select LAS storage