Airborne Laser Scanner (ALS) processing

General Processing with a settings (.reg) file

1. Load in the reg file to set the specific settings for the project.
   • File > Load Settings
2. Set the GoTo Folder to the main project directory
   • File > Set GoTo Folder
3. Check the settings are appropriate for the project before proceeding (see below). This is important if using a reg file for a different project.
4. Add the raw SCN data
   • Click Add and browse to the parent raw data directory. This will add all flight lines in the immediate child directories.
5. Select POS filename
   • Click Browse and add the .sol file
6. Select the Output directory
   • Click Select > GoTo Folder and select <projname>/ProcLaser. You should create directory if it doesn't exist.
7. Save settings for future re-processing purposes.
   • File > Save Settings
8. Run the processing
   • Run > Run

Setup of the system

• Hardware options. Once set these should never change (unless the system is modified etc) Should be supplied when the system is delivered. Can view/set these from File > Processing Options.
• Output file options. Set the projection details, LAS file format, and whether want GeoTIFF or ASCII output awswell. Also contains options for debugging.

• Input options
  • Atmospheric Correction. Need values of the altitude, temperature and pressure for a low altitude and high altitude. With these values a correction gradient will be produced.
  • Range Correction. A time-distance delay in metres of the ALS system, in the measurement of range data. (This is complicated...see user manual for details)
  • Scanner Correction. These do not need to be changed after the calibration/boresighting of the system.
  • POS errors. Angular difference between the IMU and the ALS optics reference frames. Needs to be known accurately.
  • Elevation offset. This is usually non zero. It is identified using the TScan Control Report (eh?). The LIDAR is then reprocessed using the opposite of the DZ offset.
  • Itenisty. Use the Raw intensity.